Unmachined Flywheel casting
2 posters
Page 1 of 1
Unmachined Flywheel casting
by ettingtonliam Sun Nov 15 2020, 12:26
This casting was made for a Stuart Turner 1/2hp open crank engine, a project that is not now going to happen. It is unmachined, just as it came from the foundry. It is 12" dia, 2 1/4" wide and the boss will machine out to accept a 1" dia crankshaft. 6 curved spokes, and is heavy, probably about 20 - 30 lb, so is collection only from Inkberrow near Worcester.
£50.
Richard Wilson
£50.
Richard Wilson
Last edited by ettingtonliam on Sun Nov 15 2020, 19:30; edited 1 time in total
ettingtonliam- Posts : 4
Join date : 2012-11-26
Re: Unmachined Flywheel casting
by Woodsman Sun Nov 15 2020, 17:02
Best not to include your email address Richard - too many spammers around.
Suggest you edit, remove email and ask for Personal Message
Suggest you edit, remove email and ask for Personal Message
_________________
Regards Paul
Tha can alus tell a Yorkshireman - but tha can't tell him much.
Woodsman- Admin
- Posts : 2818
Join date : 2014-08-24
Age : 73
Location : God's own county
Similar topics» How / Is it possible to date a Lister D from the casting numbers?
» Petter M Apple/ Acorn/ Straight sided hopper casting help required
» Using Master Bond Supreme industrial epoxy for Bonding, Sealing and Casting
» jap 2 a flywheel
» Norman S/C
» Petter M Apple/ Acorn/ Straight sided hopper casting help required
» Using Master Bond Supreme industrial epoxy for Bonding, Sealing and Casting
» jap 2 a flywheel
» Norman S/C
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum