www.ukengineforum.forumotion.com
Please log in , the forum is open to guests who are now able to view most sections, feel free to become a member , you will then be able to post and reply to topics.

Join the forum, it's quick and easy

www.ukengineforum.forumotion.com
Please log in , the forum is open to guests who are now able to view most sections, feel free to become a member , you will then be able to post and reply to topics.
www.ukengineforum.forumotion.com

A Stationary Engine Enthusiasts Forum


Bental Swift Corn Mill

www.ukengineforum.forumotion.com :: Stationary Engine Section :: Pumps & Engine Driven Equipment

Go down

Bental Swift Corn Mill Empty Bental Swift Corn Mill

Post by Squeekinman Tue Mar 11 2014, 22:23

How on earth do you remove the grinding plates - I have removed the cover and the small 'plug' at the end of the shaft and come to a 'grinding' halt - is the end plate on a taper on the shaft - it appears that it should just pull off, but no amount of heavy engineering will shift it - any ideas would be welcome -
Squeekinman
Squeekinman
Born to be wild
Born to be wild

Posts : 20
Join date : 2010-02-27
Age : 81
Location : Peterborough Cambs

http://graham@gjwade.com

Back to top Go down

Back to top

- Similar topics

www.ukengineforum.forumotion.com :: Stationary Engine Section :: Pumps & Engine Driven Equipment

 
Permissions in this forum:
You cannot reply to topics in this forum