www.ukengineforum.forumotion.com
Please log in , the forum is open to guests who are now able to view most sections, feel free to become a member , you will then be able to post and reply to topics.

Join the forum, it's quick and easy

www.ukengineforum.forumotion.com
Please log in , the forum is open to guests who are now able to view most sections, feel free to become a member , you will then be able to post and reply to topics.
www.ukengineforum.forumotion.com

A Stationary Engine Enthusiasts Forum


Shaft Size

2 posters

www.ukengineforum.forumotion.com :: Stationary Engine Section :: Stationary Engine General Issues

Go down

Shaft Size Empty Shaft Size

Post by Gary.B Fri Aug 09 2013, 16:50

I'm looking for a pully for my JAP 2A, I've measured the shaft and its reading 17.5mm or 11/16 inch is that the official measurement or should I be looking for a pulley the that takes a 3/4 inch shaft?

Thanks again guys

Gary

_________________
I don't actually have a clue what I'm doing. Rolling Eyes
Gary.B
Gary.B
Expert
Expert

Posts : 74
Join date : 2013-06-13
Age : 56
Location : Scotland

Back to top Go down

Shaft Size Empty Re: Shaft Size

Post by Abes Fri Aug 09 2013, 19:00

Might have one knocking around mate ill take a gander for you later

Gary.B wrote:I'm looking for a pully for my JAP 2A, I've measured the shaft and its reading 17.5mm or 11/16 inch is that the official measurement or should I be looking for a pulley the that takes a 3/4 inch shaft?

Thanks again guys

Gary

_________________
affraid A stationary engine is like peeing your pants, everyone can see it but only you get that nice warm feeling: affraid
Abes
Abes
Admin

Posts : 1269
Join date : 2011-07-24
Age : 65
Location : Ringwood

Back to top Go down

Shaft Size Empty Re: Shaft Size

Post by Gary.B Fri Aug 09 2013, 20:57

Abes wrote:Might have one knocking around mate ill take a gander for you later

Gary.B wrote:I'm looking for a pully for my JAP 2A, I've measured the shaft and its reading 17.5mm or 11/16 inch is that the official measurement or should I be looking for a pulley the that takes a 3/4 inch shaft?

Thanks again guys

Gary
That would be great if you have, thank you. bounce 

_________________
I don't actually have a clue what I'm doing. Rolling Eyes
Gary.B
Gary.B
Expert
Expert

Posts : 74
Join date : 2013-06-13
Age : 56
Location : Scotland

Back to top Go down

Shaft Size Empty Re: Shaft Size

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

www.ukengineforum.forumotion.com :: Stationary Engine Section :: Stationary Engine General Issues

 
Permissions in this forum:
You cannot reply to topics in this forum