My engines
+3
matt86
Abes
Matth92
7 posters
Page 1 of 1
My engines
Was having a dig around on the laptop and thought Id upload some photos of my current engines.
Ruston PT 1.5hp 1946, purchased last year as a non runner, but did get it going for a few minutes without too much fuss, but the frost damage turned out to be much worse than first thought, and on closer inspection it appeared the engine had been left full of water for quite a while, but this has all been cleaned out, frost damage has been repaired, just needs a set of rings, the new main bearings fitting into a Wolseley WD housing, as they are slightly different to Ruston bearings, but if a cut out is made in the housing for it to clear the timing gear housing, it will work fine, the thread on the end of the crank also needs attention.
Ex-Aerograph Villiers WX11, bought as a runner
now part of an alfa-laval milking set
1942 Fowler 1PAL
1958 Wolseley WD8, unusual petrol/paraffin version, bought as a non runner at the GDSF last year, got it back to the van, and put my NOS mag on it and away she went, will soon be getting the nasty paint took off and an oil change
Bernard WO, bought as a non runner for peanuts last year, got it running, but it smokes terribly, and main bearings are shot, also needs the broken radiator studs drilling out, now on a nicer trolley!
1937 International LA, before and after, she has gone nice and rusty now that nasty dulux has been taken off, was advertised as a runner but wasnt, have now overhauled the mag with a new coil and she starts and runs lovely now
1951 Petter W1VO 2HP, Purchased 2010 as a non runner but soon had her revving up
1946 Avon, purchased as a runner early 2011, has had a new trolley and other minor work though
Ruston PT 2hp, early villiers mag model, cracking little thing
Japy TY2, passed through my hands a few years back and I never got on with it, but now it has landed back, and apart from the carb being a bit dodgy, now I am a bit older and wiser (Older anyway!) I have got her running fairly well, just needs a trolley and end float took up on the mains
That is all
Ruston PT 1.5hp 1946, purchased last year as a non runner, but did get it going for a few minutes without too much fuss, but the frost damage turned out to be much worse than first thought, and on closer inspection it appeared the engine had been left full of water for quite a while, but this has all been cleaned out, frost damage has been repaired, just needs a set of rings, the new main bearings fitting into a Wolseley WD housing, as they are slightly different to Ruston bearings, but if a cut out is made in the housing for it to clear the timing gear housing, it will work fine, the thread on the end of the crank also needs attention.
Ex-Aerograph Villiers WX11, bought as a runner
now part of an alfa-laval milking set
1942 Fowler 1PAL
1958 Wolseley WD8, unusual petrol/paraffin version, bought as a non runner at the GDSF last year, got it back to the van, and put my NOS mag on it and away she went, will soon be getting the nasty paint took off and an oil change
Bernard WO, bought as a non runner for peanuts last year, got it running, but it smokes terribly, and main bearings are shot, also needs the broken radiator studs drilling out, now on a nicer trolley!
1937 International LA, before and after, she has gone nice and rusty now that nasty dulux has been taken off, was advertised as a runner but wasnt, have now overhauled the mag with a new coil and she starts and runs lovely now
1951 Petter W1VO 2HP, Purchased 2010 as a non runner but soon had her revving up
1946 Avon, purchased as a runner early 2011, has had a new trolley and other minor work though
Ruston PT 2hp, early villiers mag model, cracking little thing
Japy TY2, passed through my hands a few years back and I never got on with it, but now it has landed back, and apart from the carb being a bit dodgy, now I am a bit older and wiser (Older anyway!) I have got her running fairly well, just needs a trolley and end float took up on the mains
That is all
_________________
Cheers, Matt
3 X Shafty Lister D's, Fowler 1PA, Wolseley WD2, Ruston PT, Bamford EG1, Conord F2, Superbloc 3hp, Hartop M, Wrekin mill, and a girt dairy setup!
PROPER JOB
Matth92- Life Member
- Posts : 694
Join date : 2012-05-10
Location : Sunny dorset
Re: My engines
Some great looking engines there mate
_________________
A stationary engine is like peeing your pants, everyone can see it but only you get that nice warm feeling:
Abes- Admin
- Posts : 1269
Join date : 2011-07-24
Age : 65
Location : Ringwood
Re: My engines
Just tragic about the lack of dulux on nearly all of them
_________________
Cheers, Matt
3 X Shafty Lister D's, Fowler 1PA, Wolseley WD2, Ruston PT, Bamford EG1, Conord F2, Superbloc 3hp, Hartop M, Wrekin mill, and a girt dairy setup!
PROPER JOB
Matth92- Life Member
- Posts : 694
Join date : 2012-05-10
Location : Sunny dorset
Re: My engines
LOL suggest you pull your finger out then mate and get some colour on them
_________________
A stationary engine is like peeing your pants, everyone can see it but only you get that nice warm feeling:
Abes- Admin
- Posts : 1269
Join date : 2011-07-24
Age : 65
Location : Ringwood
Re: My engines
my opinion is if you like the origional look is to leave the paint on them unless its nasty paint then give them a brush over in original color if not that bad just keave them .
matt
matt
matt86- Admin
- Posts : 5577
Join date : 2011-03-29
Age : 38
Location : swindon/ faringdon
Re: My engines
Quite agree mate there's alot to be said for the working clothes look
_________________
A stationary engine is like peeing your pants, everyone can see it but only you get that nice warm feeling:
Abes- Admin
- Posts : 1269
Join date : 2011-07-24
Age : 65
Location : Ringwood
Re: My engines
Abes wrote:Quite agree mate there's alot to be said for the working clothes look
good man , if the engine has no paint at all i might paint like in the fowler case ...a small engine so not that much hastle
matt
matt86- Admin
- Posts : 5577
Join date : 2011-03-29
Age : 38
Location : swindon/ faringdon
Re: My engines
oh yes,but there a bugger to get into the washing machine when there dirty...lol..
nice collection the young man..keep it up..
mike....
nice collection the young man..keep it up..
mike....
_________________
NOT HERE FOR A LONG TIME, JUST HERE FOR A GOOD TIME
SEEMS TO BE WORKING...
mike d- Life Member
- Posts : 7594
Join date : 2009-08-26
Age : 63
Location : DORSET..BORN AND BRED AND PROUD OF IT.
Re: My engines
Nice collection ,what about the others that have fallen down that hole in your shed
Jonesey
Jonesey
JONESEY- Admin
- Posts : 2848
Join date : 2009-07-21
Age : 62
Location : Verwood, Dorset
Re: My engines
hi there matt
nice collection of engines there
keep it up mate ,
kev
nice collection of engines there
keep it up mate ,
kev
_________________
" IF YOU DONT DO ANYTHING " "" YOU'LL NEVER MAKES MISTAKES ""
kevjhnsn- Life Member
- Posts : 3596
Join date : 2011-02-10
Age : 46
Location : south cheshire
Re: My engines
haven't you heard Chris..the hole has been repaired now...
no more things falling down the hole...
i haven't seen any proof of this though
i recon hes just saying that hes repaired it to stop it taking the p--s out of him..lol
mike...
no more things falling down the hole...
i haven't seen any proof of this though
i recon hes just saying that hes repaired it to stop it taking the p--s out of him..lol
mike...
_________________
NOT HERE FOR A LONG TIME, JUST HERE FOR A GOOD TIME
SEEMS TO BE WORKING...
mike d- Life Member
- Posts : 7594
Join date : 2009-08-26
Age : 63
Location : DORSET..BORN AND BRED AND PROUD OF IT.
Re: My engines
Nice collection of engines and equipment you have matt. Where did you get the coil for your International LA coz I need to overhaul the mag on my LB and need parts for it.
Stu.
Stu.
Guest- Guest
Re: My engines
Mine was the same coil as a wolsley, petter A etc, but some of the mags on em are a bit different
_________________
Cheers, Matt
3 X Shafty Lister D's, Fowler 1PA, Wolseley WD2, Ruston PT, Bamford EG1, Conord F2, Superbloc 3hp, Hartop M, Wrekin mill, and a girt dairy setup!
PROPER JOB
Matth92- Life Member
- Posts : 694
Join date : 2012-05-10
Location : Sunny dorset
Re: My engines
Nice little collection there Mr H, you will be catching up with your caravan collection soon too,
you will need a bigger van soon,
Ian
you will need a bigger van soon,
Ian
_________________
Nelson Jumbo 1 3/4hp ,Petter M 3hp appletop, 1940 LISTER D with sheep shearing, 1951 Lister D reverse rotation, H1 H2 H3 pumps, Climax no2 pump,
ian webb- Life Member
- Posts : 657
Join date : 2009-08-27
Age : 59
Location : christchurch dorset
Re: My engines
for a young feller of 19 hes doing great....
keep it up MR H......
that's his new name from now on...MR H
the other can be MR tite ass...lol..lol..
keep it up MR H......
that's his new name from now on...MR H
the other can be MR tite ass...lol..lol..
_________________
NOT HERE FOR A LONG TIME, JUST HERE FOR A GOOD TIME
SEEMS TO BE WORKING...
mike d- Life Member
- Posts : 7594
Join date : 2009-08-26
Age : 63
Location : DORSET..BORN AND BRED AND PROUD OF IT.
Re: My engines
perservation or restoration is the name of this game
preserve as is, and keep it going or
stripe and restore to the factory finish
i have a mixture in my collection
paint what really needs it
and leave it for the rest of them
kev
preserve as is, and keep it going or
stripe and restore to the factory finish
i have a mixture in my collection
paint what really needs it
and leave it for the rest of them
kev
_________________
" IF YOU DONT DO ANYTHING " "" YOU'LL NEVER MAKES MISTAKES ""
kevjhnsn- Life Member
- Posts : 3596
Join date : 2011-02-10
Age : 46
Location : south cheshire
Re: My engines
mike d wrote:for a young feller of 19 hes doing great....
keep it up MR H......
that's his new name from now on...MR H
the other can be MR tite ass...lol..lol..
I can guess who your talking about now, he can't help it that he has deep pockets and short arms
Stu.
Guest- Guest
Re: My engines
stationary stu wrote:mike d wrote:for a young feller of 19 hes doing great....
keep it up MR H......
that's his new name from now on...MR H
the other can be MR tite ass...lol..lol..
I can guess who your talking about now, he can't help it that he has deep pockets and short arms
Stu.
ahhhem i know exactlly who your talking about just because he wont buy the misses a caravan lol
matt
matt86- Admin
- Posts : 5577
Join date : 2011-03-29
Age : 38
Location : swindon/ faringdon
Similar topics
» My engines
» A few new engines
» What engines do we all have then?
» A few of my engines
» Here we go the new engines....
» A few new engines
» What engines do we all have then?
» A few of my engines
» Here we go the new engines....
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum