Lister D cylinder head skim.
2 posters
Page 1 of 1
Lister D cylinder head skim.
Hi, Does anyone know the maximum permissible skim you can do on a D head ?
In one corner of mine is a run-off and I can get a 6 thou feeler under it, its only in a small area and dos"nt look like its where anyone as damaged it in the past removing the head, its more like erosion !!
If anyone"s any info would be nice ?
cheers, Chris.
ps, its not in any areas around the piston bore and everywhere else is nice and flat.
In one corner of mine is a run-off and I can get a 6 thou feeler under it, its only in a small area and dos"nt look like its where anyone as damaged it in the past removing the head, its more like erosion !!
If anyone"s any info would be nice ?
cheers, Chris.
ps, its not in any areas around the piston bore and everywhere else is nice and flat.
chris54-bikes- Born to be wild
- Posts : 25
Join date : 2016-01-02
Age : 69
Location : Sth Yorkshire
Re: Lister D cylinder head skim.
Head gasket should take that up ok. Use a proper composite gasket and it should be fine, if you do go down the skimming road then 6 thou should be enough.
Appletop- Life Member
- Posts : 1479
Join date : 2010-01-02
Age : 56
Location : Just outside Diss
Similar topics
» Lister 6/1 CS cylinder head
» Cylinder Head Problem - Lister D
» What paint for air cooled cylinder head
» JAP 2A Cylinder head gasket
» Petter a11 cylinder head
» Cylinder Head Problem - Lister D
» What paint for air cooled cylinder head
» JAP 2A Cylinder head gasket
» Petter a11 cylinder head
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|