bsa 120 POWER UNIT with a goodenough WATERPUMP

I got this set up with the engine incomplete, but at the last rally managed to pick up a bsa 120cc doner unit for a cylinderhead ,carb linkage ect that was needed for mine.
i have managed to loose all but a few shots of the before and during picks ,so this story will jump faster than usual for me
heres a clue to the state it was all in before i set to work






had about 6 colours and 1.5mm of paint thickness were the paint still was left
been restored back to the first topcoat colours .
kev

here the restored and repaired parts going back together

detailing isnt my best by far as just copied the casting letters ,and need to fill up the grey in places as sunk were it tryed to fill up the low parts with a good few coats over the day .but looks like the last one got away from me and didnt return to check it till pics today
kev

Hi Kev,
Cracking transformation there.You were lucky to find a good donor engine - just shows these donors are out there, its just a matter of finding them.
All the best,
Kev.

Hello Kev - I have to echo kevs sentiments - a lovely restoration - and a lucky find - are the internals as clean as the outside? All working well?

best

Hamish

all spot on ,and also rebored out to +10 thou and a new set of rings and piston,and a new oil seal and gaskets all round made or bought to finish, all the rest of gears, bearings shells ect were as good as any new engine still
kev